Scotts accugreen 30004/4/2024 Adjust the screw until the calibration line and raised ridge or front edge of the shut-off bar meet.įor Rectangular Lawns: Apply two header strips across each end for a turning area. To adjust the alignment, use a small wrench to turn the black calibration screw at the lower end of the control wire leading from the micrometer rate setting barrel. With the micrometer set at 6 and the trigger squeezed against the handle, the front edge of the projecting ridge on the shut-off bar should be aligned with the calibration line located on the 2nd or 3rd tooth from the center. Turn the spreader over so that you are looking at the outside of the bottom of the hopper. You can see the video on the spreader's page or you can follow these instructions:Ĭheck the calibration by first adjusting your micrometer setting to 6. If you don't find the Scotts Turf Builder Classic Drop Spreader listed on the bag it doesn't mean it can't be used, it just means you will have to calibrate it to find out what setting is the right one. The setting instructions are found on the back side of the fertilizer bag, the spreaders they list will be ones the manufacturer has tested their product on. The setting to use on a spreader will depend on the product being used.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |